· V2.0.0 (21/03/19) o New § Reduce the frequency of several SNTP and SMTP related events to once every 24 hours and change log text to reflect § Set display to sleep after 2 mins of inactivity § Shut off expansion panel power supply if short detected and log § Provision hardware for expansion panel § Add software redundancy for busbar eeprom o Bugfix § Increase time on busy log check to allow firmware upload § Fix footer alignment · v1.3.7 (17/01/19) o New § Small negative counts now display as 0 rather than -x.x § Single current detection chip repeated failure now reboots the feed (up to twice per hour) § Updated SSL cipher for enhanced security and performance § Updated all paths to relative to / § Update drivers and middleware § Revamp users UI § Add additional security level, device users § Change heading 1 styles § Update help § Update graphs to allow the selection of 2 sensors to display o Bugfix § Fix ajax on high latency connections § Remove update alarms button from readonly users UI § Fix integration between acegate and users/firmware forms · v1.3.6 (17/10/18) o New § OLED default screen optimisations § Add Relay and External Inputs to OLED § Add low battery check and log § Allow custom calibration coefficients in Factory setup § Data log § Remove busbar sensor values if busbar is disconnected during operation § Add automatic firmware recovery from external flash if device fails to boot multiple times § Increase accuracy of feed voltages § Increase feed VDD accuracy § Increase frequency of NTP requests if the current time is old o Bugfix § Adjust conflicting wording in help for Relay and External inputs § Update non threadsafe functions where required § Fix factory page intermittent crashing web server § Stop repeated feed disconnecting and reconnecting errors when feed is missing · v1.3.5 (05/09/18) o New § Add details to firmware failure logging and messages § Add error message when busbar disconnected to feed · v1.3.4 (03/09/18) o New § Update Busbar calibration coefficient for new shunt o Bugfix § Fixed hang on single feed power interruption during firmware update · v1.3.3 (30/08/18) o New § Increase speed of firmware upload § Streamline changing of network settings § Update OLED UI § Added EULA § Update Relay and External Inputs in help o Bugfix § Fix external inputs ports · v1.3.2 (23/08/18) o New § Performance improvements § Add firmware update successful message in web interface § Add firmware version when valid firmware is updated § Configure defaults to blank for all alarms § Update help for SNMP v2c and v3 § Add event log error when SMTP authentication fails § Add domain\ to smtp authentication description field § Remove border on read-only checkboxes for non-admin users § OLED display optimisation § Increase ext temp and humidity sensor read frequency o Bugfix § Fix dashboard mid sized view alignment when one feed is failed § Fix submit button on alarms page when logged in as non-admin user § Hide 0A displaying on failed feeds for CB/Fuse 2-12 · v1.3.1 (15/08/18) o New § SNMPv3 § Updated hardware